
_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/

     SkyPDF 7 install guide
                                                         SKYCOM Corporation

_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/

[Attention]

 - If using older version of this soft, uninstall the older version first, 
   then start the installation.

 - Administrator privileges are required for installation.


[How to install]

  1. Run SkyPDFSetup.exe.

    CD-ROM
     When insert the CD-ROM into the CD-ROM drive, SkyPDF set up launcher screen 
     appears.
     If the set up launcher screen does not appear, or installing from other
     than CD-ROM, double click "SkyPDFSetup.exe" inside the folder.
    
    ZIP file
     When the data is packed as a ZIP file, right click and select [open all] 
     to unpack it. 
     Double click "SkyPDFSetup.exe" inside the decompressed folder.

  2. When the set up launcher screen appears, check to the optional function 
     which you want to use, and choose the language from the pull down menu in
     lower left, then click [Start Install].

  3. In the InstallShield Wizard screens, enter the requested information 
     as described and click [Next] to proceed.

  4. When the Ready to Install the Program screen is appeared, 
     click [Install].
   
  5. When PDF file association setting is enabled, PDF property screen is appeared.
     Click Change > SkyPDF 7 > OK > OK.
     
  6. In the SkyPDF Setup screen,
     select the service that wants to be used in SkyPDF, then click [Decide].

      Note: You can change this setting anytime.

  7. Click [Finish].

  8. When the Setup launcher screen appears again, click [Exit]. 



[When an error has occurred during the installation]

 This section explained the solution when the below messages appear and fail to 
 installation.

  Message: (C:\Windows\System32\Wbem) is not environment variable. 
           Installation cannot continue.
           Please refer to [readme_eng.txt] about the setting step.

  1. Click [Control panel] - [System] - [Advanced system settings] - [Advanced] tab
     - [Environment Variables].
     Environment Variables screen appears.

  2. Click "Path" on System variables category, then click [Edit].
  
  3. Add "%SystemRoot%\System32\Wbem".
  
   Windows 8.1
    (1) In the [Variable value] field, press End key to put the cursor 
       at the end of line.
    (2) After ";" (semicolon), type "%SystemRoot%\System32\Wbem".
      (Example) Before "C:\Windows"
                 After "C:\Windows;%SystemRoot%\System32\Wbem"
    (3) Click [OK].
  
   Windows 10
    (1) Click [New].
    (2) Type "%SystemRoot%\System32\Wbem".
    (3) Click [OK].

  4. Click [OK] on Environment Variables screen.
  
  5. Click [OK] on System Properties screen.

  6. Reboot the computer.

  7. When the computer is started, try the installation again.


_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/
